Cleaning A Deck With A Pressure Washer

Cleaning A Deck With A Pressure Washer

A pressure washer can be your most important tool for carrying out your chores, assisting you in carrying out many tasks in a short period of time. Such as, reviving an old, tired wood deck in 30 minutes or less. However, it can blast your wood deck to smithereens if you mishandle it. This article is meant to show you how you can properly clean a deck using a pressure washer. The same procedure can be used for cleaning outdoor furniture, removing oil spillage from your driveways, washing the siding of your house and a lot more. The following are steps to follow for proper cleaning of your deck with a pressure washer:

Step 1:

Get the site prepared. Start by removing everything from the deck, most especially breakables. Then remove leaves and other related debris by sweeping. This can help in revealing tough stains from tree sap, mildew etc.

Step 2:

Ensure embedded dirt are properly loosen by applying a deck cleaner. However, you can ignore this step if the deck is lightly soiled only. Begin by getting the pressure washer soap dispenser filled with the cleanser, and by adhering to the instructions of the manufacturer. These can include getting nearby plants wet with plain water before and after the application of the cleanser. The water and cleanser will get combined by the pressure washer, so you wouldn’t have to worry too much about diluting it.

Next, let the right soap dispensing nozzle be installed on the tip of your pressure washer wand. (However, some models have an all in one adjustable nozzle that can easily be changed with a twist.) Then have the machine powered up, and get the cleaner distributed all over the deck, using overlapping or long strokes.

Step 3:

Make use of a good scrub brush for working the cleaner between railways and into tighter areas or corners. This will help in preventing streaking. Make sure the detergent does not dry off.

Step 4:

Use the widest spray type of nozzle. Start by pressure washing the deck, moving alongside the wood grain in a wide sweeping motion. Let the nozzle be like about two (2) feet away from the surface and move closer as required. You may damage the wood if you get closer more than 6 inches. When the work is done, turn off the pressure washer and pull its trigger so as to get any leftover pressure released and drain the water line.

In case you find these steps tedious, you can use lavage Haute pression Aquashine, to rather have a faster and easier pressure washing experience.

Categories: Home

About Author